Summer Starts Here - Save up to 70%
Firestone Coil-Rite Air Helper Springs Installation - 2009 Kia Sedona- Video
Today on our 2009 Kia Sedona, we'll be installing the Firestone Coil-Rite Air Helper Springs, part number F4138. We'll need to lower the rear control arm to remove the coil spring. There are two way to lower the control arm. One, by removing the wheel and the outer control arm bolt from the knuckle, and then slowly lowering the arm to release the spring tension, and then remove the spring; or to remove the inner control arm bolt, loosen the outer bolt, and allow a jack to slowly lower the control arm to release the tension on the spring, and then remove it. We're going to go with option 2 of removing the inner bolt and loosening the outer one. To start, we're going to go ahead and loosen the outer bolt. We'll just need to back it off a little bit, so that it will free up the arm and allow it to swing down. more
12/18/2014 12:42:12 PM
Trailer Brake Controller Installation - 2003 Kia Sedona- Video
Today on our 2003 Kia Sedona well be installing the ETBC7 brake controller install kit and our Tekonsha Prodigy P3 brake controller, part number 90195. Well first need to disassemble the interior of the vehicle to gain access to the wiring. Our first step will be removing the rear threshold. To do this well remove the fastener caps. Once we have the fastener caps out of the way we can then go ahead and remove the Phillips screws fastening the rear threshold. Once we have those out of the way well go ahead and set the threshold aside for reinstallation later. more
1/28/2013 8:40:40 PM
Trailer Brake Controller Installation - 2008 Kia Sedona- Video
Today, on our 2008 Kia Sedona, well be installing the Draw-Tite Brake Controller, part number 5100. Well be connecting with our ETBC-7 install kit. Well also be using the Tow-Ready Universal Mounting Bracket, part number 18136. Our first step will be assembling the 7-pole mounting bracket to the 7-pole connector. Well be using the hardware provided with our install kit. With that completed, we can now go ahead and connect the 7-pole bracket to the tow ready universal mounting bracket. more
8/28/2012 5:10:59 AM
Trailer Wiring Harness Installation - 2006 Kia Sedona 20036- Video
Today were going to show you a popular upgrade. We have here a four pole flat that has been installed on a vehicle. The owner has a boat trailer now and it has a five wire flat. So were going to convert that four wire to a five wire flat. We will show you how to deal with part number 20036 which is the adapter itself, and the bracket which is part number 20046. Our first step we need to do is take off the four pole and then well uninstall the bracket and put in the new bracket. It may take some force, but you have to pull to get this out of here. We actually used a rubber mallet to tap it a little bit, now this bracket can come off which we have previously loosened up. Now well install our new bracket and it will go in the same spot as before. What were going to do next is get our four pole ready which we have cleaned out with WD-40 and then were going to put in some dielectric grease. Well put that inside here and then were going to attach our four pole from our adapter inside there. more
8/7/2008 6:43:48 PM
Filter Videos
Filter Videos
